47mm steel sleeve cylinder ring help

[Spare_Parts]

So I went ahead and bought a Yamaha #14N116030000 ring set for the pw. Guess I'll find out if they are keystone or not. They were a little less than $16.

Hey Human (lol), whenever you pull the jug off can you get good pics of the cylinder wall and rings?

 

[HumanPerson]

Yeah i just got the second jug today and got it ported/matched.
Did the port mapping like you said from the original jug that i had good power and speed from.

Yeah i'll get ya some pictures tomorrow of the cast rings that i used on the first steel sleeved cylinder.

I hope i did a good enough job to get me up the hills and 35 mph again

Cleaned everything up really god but couldn't get one part of the overlaping sleeve, on the exhaust side,
less than 1mm so i'll leave it for now.

Ride Safe!


HP

 

[HumanPerson]

The cast rings actually looked really good, @Spare_Parts

The only thing i did notice was smoke. I guess just from being able to ride for less than 20 min. they have not seated yet,
thus the smoke?



Ride'm like ya stole'm!!


HP

 

[JerboaJohn]

if the best rings can't be found, how long can stock rings last without a plated surface on either side?

 

[HumanPerson]

just found this:
https://www.smokstak.com/forum/showthread.php?t=39101

 

[HumanPerson]

so we can stack rings?

 

[JerboaJohn]

^ that thread mentioned Otto Gas Engine Works, www.ringspacers.com and might be a cheap way to get pistons and/or rings...

 

[HumanPerson]

He says to call

 

[HumanPerson]

damn it i wanna cal them now!

 

[JerboaJohn]

looks like he can do almost anything to a ring for like 5 or $6. now i want a sleeved jug too!