FurryOnTheInside
In Memoriam
I have been messaging the manufacturer of the stainless steel top hat sprockets on eBay and after some thought and measuring I have asked him to make a stainless steel top hat adapter to connect standard (cheap to replace or try different sizes) 4-bolt bicycle chainrings to the disc rotor mount of a 135mm O.L.D. mountain bike hub, in perfect alignment with the engine sprocket.
If anyone wants to get in on this, it might make it a little bit less expensive for me, haha!
At the moment I am just asking for a one-off custom made part, so if anyone else wants one it might be best to let him know while he is setting up his lathe for me.
This is for the common standard 135mm mountain bike / multi speed hubs so not the 110mm width usually found on dedicated single speed bikes, such as @Tommy Griffin was asking about on the thread which inspired this one.
Thanks Tommy for putting me in contact with the manufacturer here http://www.ebay.com/itm/Motorized-B...ash=item2a6781ea1d:g:~3MAAOSwa-dWh719&vxp=mtr
If anyone has thoughts on the design I'd love to hear them.
If anyone wants to get in on this, it might make it a little bit less expensive for me, haha!

At the moment I am just asking for a one-off custom made part, so if anyone else wants one it might be best to let him know while he is setting up his lathe for me.

This is for the common standard 135mm mountain bike / multi speed hubs so not the 110mm width usually found on dedicated single speed bikes, such as @Tommy Griffin was asking about on the thread which inspired this one.
Thanks Tommy for putting me in contact with the manufacturer here http://www.ebay.com/itm/Motorized-B...ash=item2a6781ea1d:g:~3MAAOSwa-dWh719&vxp=mtr
If anyone has thoughts on the design I'd love to hear them.

Last edited:
Links to eBay may include affiliate code. If you click on an eBay link and make a purchase, this forum may earn a small commission.