A possible increase in hp?

[gone_fishin]

here ya go: http://www.motoredbikes.com/showthread.php?4854

 

[azbill]

nice graphic 8) 8) 8)

 

[gone_fishin]

thanks, 'kronic, now that i've started the project (the manual) i'm kinda into it, i hope more people get involved, too

"the joe"...lol, that's too funny, jeff

 

[Guest]

Funny jeff, very funny!
Did ya' see the picture I dedicated to you in the Photo section?...no it didn't have anything to do with the screw....

 

[jeffspeeder]

yes i saw the pic dont worry ill shall get one to

why did you dedicate it to me again?
looks as if you were doing more then 45 in that pic were you keeping track?

 

[JosephGarcia]

Thanks alot, Joe. if it's safe to run with a 40:1 oil fuel mix, I'll do that then. I've had some unburned oil drip out of the exhaust before, so I'll cut back on the oil, then. And I'll set the metering needle at 2 grooves from the bottom. thanks again!!

I've been running 40:1 for about 3 weeks now, my engine has been broken in about 8 months ago, I've never had this engine run better than it does with 40:1

 

[Bufu racing#1]

I dont receive my China motor until next week. But I was thinking that if I took off my air filter and attached a computer fan in place and sealed it, do you think it would increase hp when turned on? Just thinking.......... please no criticism necessary!!!!

Lol

Go buy a dremel and make your exhuast and intake ports wider ..

 

[butre]

dremels are junk. dental drills or milling machines is what you want. dremels are underpowered and fragile and incredibly overpriced.

 

[HeadSmess]

another lazarus thread...

perchance, i just happened to pull my dental drills out of storage last night... the bugs starting to bite again. screw the ban!

 

[Frankfort MB's]

I use carbide bits for a air drill and it works like a charm....