Urban Fatbiker
Well-Known Member
I measured tubes this afternoon to do something like that. Funny, I meant to correct that post, I’m not buying isolators, but isolating frame from mounts.
I saw isolators looking for mounts later. Nothing like that.
I do have a welder, and was looking at cutting tubes like clamshells to spread load, using PVC braid tube cut to fit ID. So, take it a step further and weld the lower half to the ID of the U-clamps?
Downtube is 1.75” ordered the universal large up to 2” clamp.
Seat tube 1.25”, haven’t yet checked how I’ll change the SBP mount clamping.
I saw isolators looking for mounts later. Nothing like that.
I do have a welder, and was looking at cutting tubes like clamshells to spread load, using PVC braid tube cut to fit ID. So, take it a step further and weld the lower half to the ID of the U-clamps?
Downtube is 1.75” ordered the universal large up to 2” clamp.
Seat tube 1.25”, haven’t yet checked how I’ll change the SBP mount clamping.