Degoragon
New Member
- Local time
- 8:42 PM
- Joined
- Jun 12, 2020
- Messages
- 21
Well, My Kulana has been now one problem after another, including a recent incident that bent the rear wheel, sending it into the frame. I'm done with it for now. it's a bit small for me anyways. I'm taking the motor off, and placing it on another bike.
Looking for a replacement, I went to buy a new cruiser bike, and the shelves were cleared for 50 miles or so. Even Facebook or Craigslist was of little help. Thanks to family, I managed to find a 1960's Schwinn Hollywood Cruiser that needed some bearings and a little work. For the rear, I bought a new 26" freewheel wheel, and a single speed pedal sprocket. The problem arises when I went to bolt on the CNC sprocket hub and 38 tooth Sprocket. The hub on the wheel is Tapered, with an hourglass shape. at the edges, it is exactly 1". However, it dips down in the center to 0.68" . Does anyone have a spacer to fit the gap, or will I have to have one made?
Any ideas?
Looking for a replacement, I went to buy a new cruiser bike, and the shelves were cleared for 50 miles or so. Even Facebook or Craigslist was of little help. Thanks to family, I managed to find a 1960's Schwinn Hollywood Cruiser that needed some bearings and a little work. For the rear, I bought a new 26" freewheel wheel, and a single speed pedal sprocket. The problem arises when I went to bolt on the CNC sprocket hub and 38 tooth Sprocket. The hub on the wheel is Tapered, with an hourglass shape. at the edges, it is exactly 1". However, it dips down in the center to 0.68" . Does anyone have a spacer to fit the gap, or will I have to have one made?
Any ideas?
