Clutch Bucking Bar Too long and Clutch Problems

dhennebry1

New Member
Local time
7:17 AM
Joined
Jun 17, 2022
Messages
11
Is my bucking bar normal? I ordered a 2 stroke engine on ebay and the bucking bar looks shaved.
As well as this, the bar does not push in far enough and it doesn’t disengage the clutch or let me put the cover on.
 

Chainlube

Well-Known Member
Local time
11:17 PM
Joined
Jan 5, 2020
Messages
6,984
Post a picture of the problem area, plus another of the right side of the engine with the cover off. We'll figger you out.
 

dhennebry1

New Member
Local time
7:17 AM
Joined
Jun 17, 2022
Messages
11
Post a picture of the problem area, plus another of the right side of the engine with the cover off. We'll figger you out.
E2D05DA7-0063-4296-B030-AC0351A8A28E.jpeg
i cant currently get another photo with the cover on as i am away but the cover on the drive teeth is not able to be put on as the bar sticks out way to much. the clutch doesn’t disengage or spin.
 

Chainlube

Well-Known Member
Local time
11:17 PM
Joined
Jan 5, 2020
Messages
6,984
Ha ha, that's not even a bucking bar, that's a shear cut chunk of rod. They didn't even have the good sense to use a chop saw and dress the end. I guess you should check for the little ball inside too. Bucking bar should be 28mm X 8mm with a dimple in the end to accommodate the ball.
 

dhennebry1

New Member
Local time
7:17 AM
Joined
Jun 17, 2022
Messages
11
Ha ha, that's not even a bucking bar, that's a shear cut chunk of rod. They didn't even have the good sense to use a chop saw and dress the end. I guess you should check for the little ball inside too. Bucking bar should be 28mm X 8mm with a dimple in the end to accommodate the ball.
So it was meant to be a bucking bar? But they failed miserably??
 
Top