Bushing

[davidsis]

I pressed my bushing out, but some of it stayed behind. Think this will effect it pressing new one in? Also the bottome appears to be needle bearings. Can anyone confirm this?

http://i28.tinypic.com/2rcrcyh.jpg

Also, What about another oil hole at say 3 o'colock

 

[davidsis]

good picture

That picture was so good I am going to post another one. What should I do about this black stuff on my head?
http://i31.tinypic.com/180tqf.jpg

 

[datz510]

If you can get a new bushing in there, it might be ok. The con rod is pretty galled up though from the looks of it. I'd press a new bushing in and call it good, personally.

 

[misteright1_99]

I've never seen the rod before in a HT, but that looks pretty scored. The head just has carbon buildup, common on 2 strokes. Just clean it off, might have to scrap it with wire brush, prob same with top of piston..