cam problem

Discussion in '4-Stroke Engines' started by drebinpk, Feb 12, 2011.

  1. drebinpk

    drebinpk New Member

    ok so i meant to take my gear box off cause the thing is junked but accidently took too much off(the crank case cover) and well came gear and all kinds of valve train fell out problem is i have no idea how it goes back in.... can anyone help me?

  2. keatonx

    keatonx Member

    I would put it in how you think it should go in, then slowly pull the starter to make sure everything is workin fine.
  3. Quenton Guenther

    Quenton Guenther Motored Bikes Sponsor

    The only issue you need to concern yourself with is........ The timing marks on the cam & crankshaft. It is next to impossible to see the marks without removing the opposite cover. If assembled wrong the valves may contact the piston and bend many parts...

    You can call me and I will try to guide you through the process.


    Have fun,
  4. HeadSmess

    HeadSmess Well-Known Member

    what engine?
  5. Old Bob

    Old Bob Member

    You could be one or two teeth off and it will pull over fine, just won't run.

    If its a Honda that is impossible.
    Last edited: Feb 14, 2011
  6. keatonx

    keatonx Member