Will'smotobikes19
Well-Known Member
This is what it looks like it was a free saw I got from a scrap pile one day.
It is a 34cc 2 stroke
It will have enough clearance for #25 chain
Drive sprocket size?
Wheel sprocket size?
Thinking high 20's
Thinking FWD like this build note does not have secondary mount areas the handle is one piece.
Just Bar stud and the 4 bolts that hold cylinder to gas tank.
Drilled the chainsaw sprocket rivets so can attach a #25 sprocket.
Thinking I will use 3 pins and peen them over on the inside of the bell, drill out the outer surface where pins are then weld the holes securing the pins to the sprocket.
Last edited: