MaxwellMathis
New Member
- Local time
- 11:27 PM
- Joined
- Aug 9, 2021
- Messages
- 9
Use a thick gasket, or two thinner ones between the cover and case.So I’m having a problem with my clutch, when the clutch cover is off the clutch works perfectly, but when I put it on it runs on the cover. Does anyone have a fix to this?
So I’m having a problem with my clutch, when the clutch cover is off the clutch works perfectly
If the clutch works fine, how is tightening the flower nut even more going to help this situation with an otherwise, fine running clutch...it will just be overly tight with wheel engaged at all times...lol...just wondering...lol...DAMIENTighten your flower nut more
OK...If he does do that, at least he will be able to back it off again if he finds its constantly engaged...DAMIENMine was doing the same thing that's how I fixed mine. Turned 1/2 turn. clutch still worked and felt
the same
You can seal in silicone RTV the front facing wire exit and run a very light smear on the magneto cover edge and it will shed water quite well. Having a full coverage front fender with a mudflap makes a difference too.If I were him I would just cut a hole in the cover to expose the plate and nut. Keeps the plate cool when overly using the clutch lever while riding. Only down side is it will slip in the rain. However shouldn't ride in the rain to begin with could fry your View attachment 156761magneto