D
Dockspa1
Guest
I recently built my first 80cc kit and was trying to adjust my Idler screw for the carb but my clutch lever kept slipping into gear and killing the engine.
I found a cheap fix that has been done before, I'm sure on this awsome forum but here it is.
Hacksaw a little groove where the lever is supposed to be locked in and shazaaam, it stays locked in. Don't make it to deep as it will be harder to release it.
Simple thinking really helps sometimes and I am a pro at simple thinking. :???:
Doc
I found a cheap fix that has been done before, I'm sure on this awsome forum but here it is.
Hacksaw a little groove where the lever is supposed to be locked in and shazaaam, it stays locked in. Don't make it to deep as it will be harder to release it.
Simple thinking really helps sometimes and I am a pro at simple thinking. :???:
Doc