Rezin
New Member
Can I increase the pressure on my clutch. Please help...
Clutch slips and surges on and off. Is there a way of increasing pressure?
- Thread starter Rezin
- Start date
crassius
Well-Known Member
- Local time
- 12:29 PM
- Joined
- Jul 23, 2012
- Messages
- 4,550
yes, there is an internal spring that can be adjusted - first, you should go through the cable & flower nut adjustments to be sure they are proper, then check that all pads are trimmed so they go all the way through their slots & touch both plates
Rezin
New Member
Cool man thank you, I got it open right now so I'll ck out that the pads are not catching on the pad cage. So what your saying is that their is a spring in between the cases that increases the pressure on the plates.
HeadSmess
Well-Known Member
- Local time
- 5:29 AM
- Joined
- May 17, 2010
- Messages
- 3,048
pop either the clutch plates or sprocket with puller that comes with "every" kit, hammer out the shaft, the spring is then easily adjusted.
you can also undo the lil adjustor thingy behind the cylinder, that holds the outer case of the clutch cable steady, and with a bit of tomfoolery, one can adjust the spring simply by jamming a screwdriver down the hole, and turning the sprocket. having pulled an engine apart before and knowing what is where helps if this method is chosen
you can also undo the lil adjustor thingy behind the cylinder, that holds the outer case of the clutch cable steady, and with a bit of tomfoolery, one can adjust the spring simply by jamming a screwdriver down the hole, and turning the sprocket. having pulled an engine apart before and knowing what is where helps if this method is chosen
