So I have a spookytooth 80cc engine kit on the way.
I guess I'm going to have to drill a hole in the bottom tube because of the angle of the mounting hardware vs the frame.
I'll use an extra long inner bolt, steel spacers, washers and bushings cut at an angle to fit flat against the frame
Then another cut bushing so the washer and nut are flat on the bushing.
like where the angled parts are the bolt and spacers, the bushing will make a flat fit on the frame, then on the other side another bushing
to flat fit the frame and the washer and bolt will also flat fit the bushing.
\ \
_\_\__
______
....\ \
I guess I'm going to have to drill a hole in the bottom tube because of the angle of the mounting hardware vs the frame.
I'll use an extra long inner bolt, steel spacers, washers and bushings cut at an angle to fit flat against the frame
Then another cut bushing so the washer and nut are flat on the bushing.
like where the angled parts are the bolt and spacers, the bushing will make a flat fit on the frame, then on the other side another bushing
to flat fit the frame and the washer and bolt will also flat fit the bushing.
\ \
_\_\__
______
....\ \
Last edited: