digital_life
Active Member
Recently my clutch stopped working and after a quick inspection I noticed the flower nut had spun out and the only thing that stopped was case.
This motor had over 6 thousand kilometers (3728 miles) and I regularly took the covers off to inspect and adjust the flower nut so I am fairly certain that all was put back together properly.
I actually have 2 question's
1. Why did this happen is it common
2. Do you know of any good videos to remove and install another shaft without splitting the case since I have a couple of these motor's that do not run.
Pictures
This motor had over 6 thousand kilometers (3728 miles) and I regularly took the covers off to inspect and adjust the flower nut so I am fairly certain that all was put back together properly.
I actually have 2 question's
1. Why did this happen is it common
2. Do you know of any good videos to remove and install another shaft without splitting the case since I have a couple of these motor's that do not run.
Pictures