I
ibeenjammin
Guest
Has anyone tried to use the Permatex - Moto gasket maker?
If you use soft aluminum to make your new gasket, do you put gasket sealer on it? When you file your intake manifold and the engine where the 2 butt up together. Are you just using a file? Do you finish it off with super fine sandpaper? Don't you want as smooth and flat of a surface as possible? I hope these questions are not too dumb. Thanks for the input. I am mainly looking for insight on what is best to replace my intake gasket, but I am thinking about what to replace the rest of my gaskets with. Thanks again