DistantWolrld101
Well-Known Member
Ah, you been pming him.
yes Sir that is how i got the picture of the clutch system he has..
Here is all the pictures i was sent so everyone has a bigger picture for helping.
Ah, you been pming him.
Pic 2 looks like the bell is off center a little bit.yes Sir that is how i got the picture of the clutch system he has..
Here is all the pictures i was sent so everyone has a bigger picture for helping.
Pic 2 looks like the bell is off center a little bit.
Edit: a lot a bit. He needs to spin the bell while on the engine to see if there is any deviation.
Also, there are springs in that clutch, they are just hidden. Not all springs are spirals. If it doesn't grab engine off, idle might pull the shoes out just enough to grab the close end of the bell if the bell is off center a little.
Nope, its's pic 5. Look at the rightmost edge of the upper clutch pad. It's lifted and will grab. That is the problem, and a new clutch will fix it.yes Sir that is how i got the picture of the clutch system he has..
Here is all the pictures i was sent so everyone has a bigger picture for helping.
Kept getting more thoughts and thinks (the trailer park boys reference), didn't want to double post .^^^^ I have seen more edits in this one post, then all the posts together since i joined xD
Greasing was needed and the screw was tightened down on the bell i mustve did that by accident. Its idles now! Even the chain felt better
that would work but one problem, the type of clutch he runs does not use a spring