Sprockets Grubee Skyhawk Sprocket Mounting

Discussion in 'Transmission / Drivetrain' started by fastfestus, Jan 7, 2010.

  1. fastfestus

    fastfestus New Member

    HI All. I'm new to the forum so be patient with me.
    I am now awaiting delivery of my Grubee Skyhawk engine kit. I downloaded the manual and was browsing thru it. I noticed that the sprocket came with two (2) rubber plates that attach thru the spokes to the sprocket. My question is: do they go together on one side of the spokes or does one go on each side of the spokes. Any help would be greatly appreciated.

  2. give me vtec

    give me vtec Active Member

    one goes on one side and one goes on the other. They sandwich the spokes. If you dont like that setup, bicycle-engines.com sells a complete hub unit that has the sprocket attached to the hub. Here is a link...


    just ask if you need anything else...
  3. KeyWest

    KeyWest Member

    fastfestus, I think you will need to cut one of the rubber plates so you can get it around the hub on the inside of the spokes. That should get erdone.
  4. snowbanana

    snowbanana Member

    I cut the rubber with an x-acto knife to get it on the hub and it seems to work fine.