Hello Needing Help

Shannon

Member
Local time
7:51 PM
Joined
Nov 14, 2017
Messages
107
I am recently a new owner of my first motorized bike (Used). I'm having problems getting to to run good i cleaned the carb and jets and stuff inside carb put in new spark plug and it has fresh gas and good compression no air leaks or any leaks My problem I believe is with my throttle cable adjustment (Both Ends) and idle screw as I don't know right adjustment for them so I played around with it to try find the right adjustment and no having any luck what is the right adjustment i should be looking for? here is some pics. bike gets to a certain speed and starts to struggle
 

Attachments

  • IMG_20171114_192612.jpg
    IMG_20171114_192612.jpg
    136.7 KB · Views: 112
  • IMG_20171114_192636.jpg
    IMG_20171114_192636.jpg
    192.5 KB · Views: 108
  • IMG_20171114_192701.jpg
    IMG_20171114_192701.jpg
    199.4 KB · Views: 97
  • IMG_20171114_192712.jpg
    IMG_20171114_192712.jpg
    288.6 KB · Views: 105
  • IMG_20171114_192733.jpg
    IMG_20171114_192733.jpg
    246.7 KB · Views: 140
throttle cable is adjusted until there is just a little bit of slack before it starts to pull the slide - idle screw is turned to a position that gives a good idle speed - these are easy

I see some oil stains under the head - clean that area by putting some gas on paper towel and working it around in there with a screw driver until clean - run the bike a bit and if stain comes back, head gasket is loose
 
is the throttle cable to be adjusted out or in to make little slack and is the adjustment for both sides of the cable? is the head gasket is loose how do i make it tight again?
 
no slack, make outer shorter - too much slack, make outer longer

IF head is loose read about correct torque here on forum
 
neither

short/long is in the adjusters

if you don't read enough to learn a bit about these, you'll never get it right
 
OK I got it running good is there away to make bike faster with idle screw or throttle cable or clutch
 
Back
Top