High quality gas tanks?

I have a '71 Kawasaki 100 tank and you need the NOS petcock and cap sometimes.. once you figure it out you can mount it with rubber bushings from an A/C compressor and some bolts with and some braces welded to the frame...
Some M/C tanks are way too big for a M/B.
 
Ive had better luck looking for moped or minibike tanks. A little customizing to mount them, but not bad. Even gave it some pizzaz with a bowling ball paint job(done with home depot spray paint)
 

Attachments

  • FB_IMG_1645317807533.jpg
    FB_IMG_1645317807533.jpg
    143.6 KB · Views: 116
  • FB_IMG_1645317816893.jpg
    FB_IMG_1645317816893.jpg
    129.5 KB · Views: 109
I've got some stuff that's in route you might like there a lot of blue in my quest for green anodized kit hydraulic clutch brake ...thumb throttles... clear 21-24mm oko carbs multi splash... Might look great with that assume tank
 

Attachments

  • Screenshot_20220215-181944.png
    Screenshot_20220215-181944.png
    334.4 KB · Views: 111
  • Screenshot_20220201-134825.png
    Screenshot_20220201-134825.png
    289.1 KB · Views: 116
Links to Amazon may include affiliate code. If you click on an Amazon link and make a purchase, this forum may earn a small commission.

TRY THESE, WON'T LEAK ON YA, NO STUDS!!
I'd second that. I picked up one a few months ago for my chopper and it's been smooth sailing all the way ! Never had an issue with it. I'd flipped the supplied mounting brackets upside-down and welded them directly to the top bar of the frame before bolting the tank to them - like Karl mentioned, no studs so you can tighten the bolts down as tight as you'd want and no leaking.
 

Attachments

  • 20220218_174146.jpg
    20220218_174146.jpg
    555.9 KB · Views: 108
  • 20210606_024301.jpg
    20210606_024301.jpg
    128.3 KB · Views: 104
Links to eBay may include affiliate code. If you click on an eBay link and make a purchase, this forum may earn a small commission.
I'd second that. I picked up one a few months ago for my chopper and it's been smooth sailing all the way ! Never had an issue with it. I'd flipped the supplied mounting brackets upside-down and welded them directly to the top bar of the frame before bolting the tank to them - like Karl mentioned, no studs so you can tighten the bolts down as tight as you'd want and no leaking.
Is that a piece of rubber for a car door opening ?
 

Attachments

  • Screenshot_20220222-083824.png
    Screenshot_20220222-083824.png
    697.7 KB · Views: 112
  • Screenshot_20220222-084246.png
    Screenshot_20220222-084246.png
    305.3 KB · Views: 112
Back
Top