Homemade reed valve, the search begins

[sp1ke]

using custom modded nuraku reed block with great sucsess as far as i can tell at this stage in my build althou there is a lot to take in to concideration with this mod especially if using external reed blocks the best good to go one is the rock solid and panthers design is good but you are restricted to that inlet size those are the easyest ways my naraku block set me back 35 gbp didnt take a lot to decrease its mass with jb weld whyle keeping a larger inlet without restriction possible similar to arrows design but im using a offset adapter i made because of fouling the frame

 

[skyash]

Have you seen the 3 or 2 stage reeds ?with three or two different Stiffness to the reeds I would like to try one .rev a little and the soft reed moves rev up more and the harder reeds move .made for pocket bikes

 

[sp1ke]

ive had boyesen twin reeds and yes there is an improvement over singles of the same material


i might try n make some multi petal carbon later on actually not a bad idea