jumpjr619
New Member
- Local time
- 7:59 PM
- Joined
- Oct 22, 2022
- Messages
- 18
Hey all so I took the motor apart down to the jug to put some RTV gasket maker because it was spewing oil mix in the front near the exhaust I put a little grease in the tube for the piston put the gasket sealer lightly tightened then waited to come back and fully tighten down bolts. And the only other thing that's noticeably broken is where the carburetor connects to the manifold and where u tighten it down with the screw ring thing well one of the 4 pieces broke off but I still got it somewhat tight so it doesn't fall off. But the issue is when I dump the clutch to get going at first I had to pull throttle wot and it would fire up but then it wasn't responding to the throttle so well so I killed it then tried it again and I almost wrecked due to the bike wanting to take off WOT and that time it was hard to kill the engine my kill switch was doing absolutely nothing. Please help need advice