Iron sleeve CG

[DieselTech]

Tillotson HL-334wx carb is .780"-.790" venturi.
If bigger venturi is needed, look at, Tillotson HL-304wx which has a .880"-.890" venturi.

 

[DieselTech]

The carb I think the best suited for us is the tillotson HL-334ab .900" venturi & is set up for reed valves already.

 

[Karl Snarl]

The carb I think the best suited for us is the tillotson HL-334ab .900" venturi & is set up for reed valves already.

I switched because re jetting sucks, lol, and jet kits are hard to come by any more. An they always leave out the 67 and 69 jet. The two I use around here. .
Im going to check those carbs out.

 

[DieselTech]

For those running the 49mm steel sleeve cylinders, if you need piston rings stihl ms390 49mm cast rings are the same.

 

[Karl Snarl]

For those running the 49mm steel sleeve cylinders, if you need piston rings stihl ms390 49mm cast rings are the same.

I want to find some molly rings. What's the price difference in sthl vs mb rings?

 

[DieselTech]

Stihl chainsaw rings are $2 cheaper from what I can find, & easier to get.

 

[DieselTech]

$8.95/set for stihl rings, I bet I can find them cheaper though.

 

[Karl Snarl]

$8.95/set for stihl rings, I bet I can find them cheaper though.

That not to bad a price, lol.