is it double the make a shift kit

Discussion in 'General Questions' started by datsun610, Jul 15, 2010.

  1. datsun610

    datsun610 Member

    hi i was thinking of weldin a 7 spd sprocket on the left side of my back wheel so i culd run gears dose any one know if it possible i found that a mountain bike chain will fit around the sprocket on the motor but will it hold up with the power or just snap i also have a old school 3 spd hub i was thinking of doing but it spins on the right not left any ony have any ideas

  2. AussieSteve

    AussieSteve Active Member

    You need to think about what you're typing a bit more, especially with thread titles.
    "is it double the make a shift kit" doesn't make any sense.

    The freewheel would work backwards. If you weld the cluster solidly to the hub, all the stress of starting will go onto the derailleur and destroy it.
    Last edited: Jul 16, 2010