Is this the same engine as a 79cc Predator ?

[Gordy]

Would this torque converter fit that engine? https://www.amazon.com/Mophorn-Converter-2HP-7HP-Replacement-CVT/dp/B019SL0LUU

Yes, but you would need a sleeve to convert it from 5/8 shaft to 3/4 shaft

 

[MuayThaiJJ]

Yes, but you would need a sleeve to convert it from 5/8 shaft to 3/4 shaft

Ok, could I get a 5/8 driver pulley? Does the 5/8" bore driven pully not mount onto the engine's output shaft?

 

[Gordy]

Ok, could I get a 5/8 driver pulley? Does the 5/8" bore driven pully not mount onto the engine's output shaft?

The driven mounts to the jackshaft on the mounting plate, the driver pulley is the one that bolts to the engine, which is a 5/8 shaft

 

[MuayThaiJJ]

The driven mounts to the jackshaft on the mounting plate, the driver pulley is the one that bolts to the engine, which is a 5/8 shaft

Ok cool, so the 5/8" driver pulley included in the kit should work then, right?

 

[Gordy]

Ok cool, so the 5/8" driver pulley included in the kit should work then, right?

The kit says the driver is 3/4, not 5/8

 

[MuayThaiJJ]

The kit says the driver is 3/4, not 5/8

Ah my bad, ok gonna grab one from Amazon

 

[MuayThaiJJ]

Here is the transmission that comes on the 156F:

Link to the 156F kit is here: https://www.aliexpress.com/item/325....order_list.order_list_main.10.42f41802m7DYjd

 

[Chainlube]

Ah my bad, ok gonna grab one from Amazon

Just be aware that you will have to cut the key shorter so the driver will fit on the crank.

 

[Leon]

View attachment 215970
This is a 98cc TITAN TX100 I bet it was made in the same Chineese plant by looking at the 156f label. Predator does not list this engine in their inventory. I think it is a bored out 79cc block with a larget piston. Does anyone know for sure?

 

[michael whiteman]

I totally agree with you Leon. Welcome to the group. Do you have, or planning to build a bike?