loncin pocket bike wont start



I bought a pocket bike with a loncin engine, I dont knoe the size. I have noticed that the carb was upside down when I got it so I checked out the carb & put it right side up but had it ****ing gas thru the overflow hose, Found there was slack on the plunger/float (is there a piece of metal that goes here?) I tweaked the plactic a bit to allow gas in then shut off but still dont start. I also notice that the carb faces the front of the bike but when I look online it shows it the other direction (air filter towards rear) when I try to flip the postion the carb hits on the starter, could I use the little spacer that connects to the carb on the upper part to add height to the bottom to turn the carb around?
Last edited by a moderator: