Mongoose Malus BBR - 2 stroke / Sick Bike - shift kit

Fishfiles

Active Member
Joined
Mar 31, 2021
Messages
132
went to digging in my parts boxes and dug up another CDI , stuck it in and it fired , then got the engine started , so all 3 of them Cat Nips must be bad or never was any good right from china ---------- next problem , the clutch will not disengage and it is idled kind of fast and there is no more adjustment on the cable
 

Fishfiles

Active Member
Joined
Mar 31, 2021
Messages
132
Finally got to look at the latest set of problem that arose on start up Saturday

1) one was the clutch not grabbing : well that seems easy enough , the set screw let go on the right side of the jack shaft , the shaft was grinded with a flat spot , but the sprocket was spinning on the shaft , guess it wasn't enough , hope that is the only problem there --- I couldn't see this shaft spinning with the Sick shift kit and the Sick tensioner kit in place

2) pull start knob pulled off : I was told the pull start was a bad thing , the rope got jammed in the pulley and the handle pulled the rope thru the plastic , was able to get it all back together with a better handle , it sure is nice pull starting it when it works , going to try it again

3) Idle too high , only way I see this getting this right is another throttle assembly , different length cable or a different carb , this is all parts of the upgrade carb and parts from the Bike Berry Kit and the cable will stick , cruise control , LOL

With that pipe this bike is loud , reminds me of a chain saw
 
Top