motor issue

Discussion in 'General Questions' started by strainjpnt, Aug 18, 2008.

  1. strainjpnt

    strainjpnt Member

    ok so i bought a Ht80 motor from dgoria and im new to these motor so my issue is that the clutch arm can swing all the way around and i have no way to dissengage the clutch please help me

  2. bluegoatwoods

    bluegoatwoods Well-Known Member

    Turn it around the other way. The arm ought to point toward the rear of the bike. Then you set up the cable so that it pulls the arm toward the curb side of the bike. Now your clutch should work just fine.
  3. strainjpnt

    strainjpnt Member

    nope that didnt work

    well i realized the guy must have lost the thing that goes into the 10t sprocket because nothing sticks out of it
  4. dwsutton

    dwsutton Member

    There should be a clutch cable, two springs and either a cable end or a small nut on the end of the clutch arm itself. The large spring goes around the bottom of the cable and acts as a heat shield and the small one goes over the bare cable between the guide and the end of the clutch arm.
    The cable goes thru the guide on the engine body and then thru the small hole in the end of the clutch arm.
  5. Yep, should be a rod and in front of that, inside the hole a ball.....