Motorised bike bucking bar too far in which causes the clutch not to work please help

Karl Snarl

Well-Known Member
Local time
11:26 AM
Joined
Sep 20, 2019
Messages
5,951
Location
Chunky Monkey Mole Hole
I tried it didn’t work unfortunately I’m going to buy a magnet
Why not spray some wd40, brake cleaner, carb cleaner etc in the hole to get out the grease. Then it will slide ride out when the engine is tilted. Heck even a box staple under it to slide it out. It's not that hard, the grease is holding it in.
 

Mossy

Well-Known Member
Local time
10:26 AM
Joined
Jan 7, 2022
Messages
2,648
Use the....
 

Attachments

  • 1ec2k8.jpg
    1ec2k8.jpg
    189 KB · Views: 54

inspectorcritic

Well-Known Member
Local time
10:26 AM
Joined
Dec 13, 2015
Messages
1,890
Go to Walmart dig deep in your pocket buy some Whamo steel shot steroids but there are 2 different sizes I for got is the smaller shot measure the bucking bar before you buy.

I had trouble with it before though I could trade it out from another motor that did not work because of a faint 2mm in length then I tried another dead exchange and it work so either the steel ball, length of bucking bar, or the next flower but adjustment or ...
 

Seansull

New Member
Local time
5:26 PM
Joined
Feb 26, 2022
Messages
20
I’m having trouble with my revs not going down and it speeds up to quick and won’t go back down and revs won’t go down either any ideas
 
Top