Motorised bike bucking bar too far in which causes the clutch not to work please help

I tried it didn’t work unfortunately I’m going to buy a magnet
Why not spray some wd40, brake cleaner, carb cleaner etc in the hole to get out the grease. Then it will slide ride out when the engine is tilted. Heck even a box staple under it to slide it out. It's not that hard, the grease is holding it in.
 
Use the....
 

Attachments

  • 1ec2k8.jpg
    1ec2k8.jpg
    189 KB · Views: 97
Go to Walmart dig deep in your pocket buy some Whamo steel shot steroids but there are 2 different sizes I for got is the smaller shot measure the bucking bar before you buy.

I had trouble with it before though I could trade it out from another motor that did not work because of a faint 2mm in length then I tried another dead exchange and it work so either the steel ball, length of bucking bar, or the next flower but adjustment or ...
 
I’m having trouble with my revs not going down and it speeds up to quick and won’t go back down and revs won’t go down either any ideas
 
Back
Top