BoltsMissing
Active Member
The pic below is shows how it panned out so far with a HT engine on 27" steel frame.
By the looks of things, some plumbing might be due..., ongoing project.
The bike being used is not a regular build bike, but using the 27" frame to "dummy" fit HT engines where special brackets are sometimes required.
So if the new carby has problems fitting on a 27" frame, then I assume it will have similar problems on MTB or 26" frames.
I think it's an oversight by the suppliers, they don't build bikes, do they ?
The new carby however looks well made, comes with cables already connected to handle-bar grips, choke levers etc. ( plug and play)
Seems good value for under $80.00 AUD
I'm thinking of plumbing the airfilter intake rather than messing with the manifold.
By the looks of things, some plumbing might be due..., ongoing project.
The bike being used is not a regular build bike, but using the 27" frame to "dummy" fit HT engines where special brackets are sometimes required.
So if the new carby has problems fitting on a 27" frame, then I assume it will have similar problems on MTB or 26" frames.
I think it's an oversight by the suppliers, they don't build bikes, do they ?
The new carby however looks well made, comes with cables already connected to handle-bar grips, choke levers etc. ( plug and play)
Seems good value for under $80.00 AUD
I'm thinking of plumbing the airfilter intake rather than messing with the manifold.