Finally Finished my Nirve Switchblade!! It was a hell of a project as I'm sure some of you know all too well... I completely avoided the typical chain tire clearance issue by using a 26 x 2.125" rear wheel Instead of the stock 24 x 3" wheel that came with the bike and a LOT of headaches avoided!! Also have a CDH sprocket Adapter with a 36 tooth sprocket, Some BadAss Chopper/Bobber style "Z" Bars and the motor I believe is a 49cc Flying Horse kit I picked up used for $60 on Offerup. And The Bike needed a Lil modification as well so I welded another tube from the bottom of the seat tube above the cranks and connecting to the downtube to get the motor where I wanted it . Also I cut the headtube off and brought the bottom in a couple of inches so the Forks weren't too raked out and it handles SO MUCH BETTER NOW!! LEMME KNOW WHAT YOU GUYS THINK THOUGH . ANY SUGGESTIONS ON On A Selling price would be greatly appreciated as well .