Noob question from a non noob regarding oko carb

[Thxcuz]

So I got an oko carb with my YD100 kit and for the life of me I can’t figure it out. There are multiple inlets and I’m not sure where the fuel line goes. I think I’m in the right place but the bike won’t start. I dump a little premix down the spark plug hole and it fires right away. I’m familiar with bing and delorto carbs I’ve even worked with mikuni and Chinese scooter carbs...those were simple. I can’t figure this one out.

I feel like a total moron because it’s a simple solution I’m sure. Before I adjust anything I’d like to know for sure I’ve got the fuel line in the right place

Any help will be appreciated

 

[Chainlube]

Angled pipe 1/4" right beside the air inlet.

 

[Chainlube]

You didn't happen to take a picture of the slide when you had it apart to install the cable?

 

[Thxcuz]

No. But that’s the next thing I’m looking at.

 

[Thxcuz]

I do know my choke isn’t working right so I recon the cable isn’t in there right

 

[Chainlube]

The choke looks like an enrichment circuit, just adds fuel to air stream, no cable. But that is just going off a generic photo, yours may be different. Got a picture?

 

[Street Ryderz]

So I got an oko carb with my YD100 kit and for the life of me I can’t figure it out. There are multiple inlets and I’m not sure where the fuel line goes. I think I’m in the right place but the bike won’t start. I dump a little premix down the spark plug hole and it fires right away. I’m familiar with bing and delorto carbs I’ve even worked with mikuni and Chinese scooter carbs...those were simple. I can’t figure this one out.

I feel like a total moron because it’s a simple solution I’m sure. Before I adjust anything I’d like to know for sure I’ve got the fuel line in the right place

Any help will be appreciated

The yd 100 engines don't come with an oko carb as far as I know they may come with a cns carb though which is what it looks like in you're picture but yours is fitted with a dio reed so idk for sure is hard to really see it, most of the oko carbs don't use a cable for the enrichment/choke it's just a pull up valve, the cns has a second cable for that circuit.

The oko carbs most commonly found on a dio reed setup look like this.

A better pic of yours would help ,the lines are pretty straight forward there are vent's from the bowl for over flow and the oko has one from the bowl to the power jet and it's bowl over flow is on the bottom with a rubber upper vent.The cns just has over flow vents one on the top of bowl and one underneath.

 

[Thxcuz]

My yd100 has the dio reed setup

 

[Thxcuz]

I’ll get a picture in the morning

 

[Thxcuz]

Pictures as promised