poppin when tryin to start it

Discussion in '2-Stroke Engines' started by A-TownTX, May 1, 2011.

  1. A-TownTX

    A-TownTX Member

    when I try to start my engine I am hearing an awful poppin sound in the clutch (not like back fire pop more like two pieces of metal pop) and this happened when I tightened up my inner clutch the other day did I tighten it up to much or what, can someone help me please.

  2. Al.Fisherman

    Al.Fisherman Active Member

    What are you working on...this should help. If it's a 2 cycle, post in the 2 cycle section, for a better response.
  3. Hammond Egger

    Hammond Egger Member

    It's probably the chain poppin off the sprocket teeth. The clutch adjustment is probably just a coincidence.
  4. DuctTapedGoat

    DuctTapedGoat Active Member

    Chain tension, chain alignment, sprocket teeth catching rollers on the chain.

    It's tough to say.
  5. A-TownTX

    A-TownTX Member

    poppin stopt

    it stopt poppin I think it was in the bearing of back tire wen i went to grease my bearings one the bearings was outta place so I kinda felt foolish . Though I put to much grease in the inner clutch and its hard to start does anyone know if it will get better in time or do I have to replace something.
  6. Al.Fisherman

    Al.Fisherman Active Member

    I'd take the clutch plate off and clean well. You can clean the pads with alcohol or a can of break or starting fluid
  7. A-TownTX

    A-TownTX Member

    kI will give that a try so do I have to follow the same procedures as tightening the clutch i dont have to go any further than taking the flower nut off or do I ? I had looked and it seems to me i may have to go in deeper is that what the thing that has threads on it and pully like thing in it