xspade17x
Active Member
So I just got this engine with a centrifugal clutch. But I didnt get a mount. I have everything else I need to put it on a bike. How could I fabricate a mount?
Predator 212cc 4 stroke engine
- Thread starter xspade17x
- Start date
- Status
get some 1/4 in plate (about a inch wider than the predator mounting plate. And about 25-30in long, depends on where the motor sits)
Then, you can either weld it streight on the frame, or get 2 u bolts (muffler clamps work a lot better) then weld them on and just bolt it up! (Dont forget to gusset the u bolts so they don't snap off)
Should be 100x better than what you can buy.
xspade17x
Active Member
I dont have a welder.
Harbor freight is going to be your friend then, i have there 80$ welder, been using it for a few years now. Not a single problem with it.
Tyler6357
Well-Known Member
Links to eBay may include affiliate code. If you click on an eBay link and make a purchase, this forum may earn a small commission.
xspade17x
Active Member
Lol I appreciate your advice but I dont have the money for that otherwise I would buy a mount. 
Tyler6357
Well-Known Member
Maybe you could build one with a trip to the junk yard.
xspade17x
Active Member
Chainlube
Well-Known Member
At the very least, you're going to need a drill press if you want to make one.
xspade17x
Active Member
Would it be better to mount it to a back seat rack?
- Status
