I'm letting you guys know that I rebuilt the engine recently in case i did something wrong and that is why it won't start.
I just replaced the cdi and stator coil on the bike, as well as getting a new spark plug. I got spark outside the engine when I turned the wheel with some force. I noticed if I didn't turn the wheel as fast I couldn't see a spark. Maybe weak spark? I'm pretty sure I installed the stator coil correctly as well as the magneto.
Anyways I assumed my spark was good because I could see a decent spark and decided to tackle the fuel side of things. Next thing I tried was pulling my carb off and taking the fuel bowl off. I blew into my main jet and the fuel intake to make sure there was nothing in there to prevent the fuel from flowing. Put the carb back on and it still wouldn't start. Next I tried to lean out my mixture using the c clip in case their was too much fuel in the mixture for it to combust.
I'm having a very difficult time telling whether or not there is fuel in my cylinder. I tried to smell the spark plug and it smelled faintly of gasoline, but upon shining a flashlight into the cylinder it appeared mostly dry.
Im considering spraying some starter fluid into the cylinder into the engine and then trying to run the motor. I figure if it runs even for a second on the starter fluid, that must mean I have good spark, and I can rule that out.
Lastly, compression. When I rebuilt the engine I put all new gaskets back in. Now, I did cut these by hand so they might not be perfect, but they all seem to be fine upon first glance. With the spark plug out, and putting my finger over the spark plug hole, I can feel some pressure on my finger as I turn the engine over. Not sure how much I should be feeling, but the pressure doesn't seem to go away if I hold the piston at the top, so I'm pretty confident my head gasket is good.
I've admittedly been a little lazy about going threw and checking everything, but I figure y'all will yell at me if there is anything particularly stupid that I've neglected to check.
Thank you all in advance for your help
I just replaced the cdi and stator coil on the bike, as well as getting a new spark plug. I got spark outside the engine when I turned the wheel with some force. I noticed if I didn't turn the wheel as fast I couldn't see a spark. Maybe weak spark? I'm pretty sure I installed the stator coil correctly as well as the magneto.
Anyways I assumed my spark was good because I could see a decent spark and decided to tackle the fuel side of things. Next thing I tried was pulling my carb off and taking the fuel bowl off. I blew into my main jet and the fuel intake to make sure there was nothing in there to prevent the fuel from flowing. Put the carb back on and it still wouldn't start. Next I tried to lean out my mixture using the c clip in case their was too much fuel in the mixture for it to combust.
I'm having a very difficult time telling whether or not there is fuel in my cylinder. I tried to smell the spark plug and it smelled faintly of gasoline, but upon shining a flashlight into the cylinder it appeared mostly dry.
Im considering spraying some starter fluid into the cylinder into the engine and then trying to run the motor. I figure if it runs even for a second on the starter fluid, that must mean I have good spark, and I can rule that out.
Lastly, compression. When I rebuilt the engine I put all new gaskets back in. Now, I did cut these by hand so they might not be perfect, but they all seem to be fine upon first glance. With the spark plug out, and putting my finger over the spark plug hole, I can feel some pressure on my finger as I turn the engine over. Not sure how much I should be feeling, but the pressure doesn't seem to go away if I hold the piston at the top, so I'm pretty confident my head gasket is good.
I've admittedly been a little lazy about going threw and checking everything, but I figure y'all will yell at me if there is anything particularly stupid that I've neglected to check.
Thank you all in advance for your help