Running 1 Piston Ring

[HumanPerson]

 

[Stingray Chopper Man]

Yeah, don't forget to follow break in procedures with new rings.

What's the break in procedures??

 

[YetiWoodz]

What's the break in procedures??

The break in procedure will last around 100 miles. Make sure your fuel mixture isn't lean. A little on the rich side is fine. Just don't ride it at peak rpm for long at all. Go on shorter rides. Don't let it idle for minutes at a time.

 

[Street Ryderz]

Running a single ring is fine if your using a piston/ring meant for it,I wouldn't do it with a stock ring the end gap is way too big.Break in is heat cycles not mileage,you can fully break in an engine in 10 miles or less if you idle it and then just do a few pulls let it cool and repeat 5 more times.

 

[Street Ryderz]

I have run one ring with the Airsil/Jog piston witch needs to be modified to do so and to me is kinda expensive. MZ has a low pin piston in 48 mm bore that is meant for their sleeved cylinder and they now have a ceramic not chromed 48 mm bore cast cylinder in witch I use the above piston with 1 mm thick rings.This gives half the resistance over stock 2 mm rings and they have proper end gaps.

Motorized bicycle 48mm LOW PIN piston for 48m sleeved cylinder | eBay

Find many great new & used options and get the best deals for Motorized bicycle 48mm LOW PIN piston for 48m sleeved cylinder at the best online prices at eBay! Free shipping for many products!

www.ebay.com

MOTORIZED BICYCLE 48MM CYLINDER SET FOR 66CC/80CC MOTOR 40MM INTAKE HIGH PIN | eBay

Find many great new & used options and get the best deals for MOTORIZED BICYCLE 48MM CYLINDER SET FOR 66CC/80CC MOTOR 40MM INTAKE HIGH PIN at the best online prices at eBay! Free shipping for many products!

www.ebay.com