SE Wiring Harness

Discussion in 'Whizzer Motorized Bicycles' started by Adam Livingston, May 10, 2008.

  1. Adam Livingston

    Adam Livingston New Member

    I just purchased an SE motor kit and wanted to ask about the wiring harness.

    I was considering perhaps a simplified Whizzer with no lights any only a kill switch and keyed ignition... what is the easiest way to build a simplified wiring harness? Purchase a complete one (I want to keep my current one in tact to use later should I change my mind) and cut it up or can I get the various connectors used in the harness somewhere and build my own?



  2. bill green

    bill green Member

    Look in your assy. manual there is a diagram for A four wire easy set up . Bill Green
  3. Adam Livingston

    Adam Livingston New Member

    Saw that ... thanks Bill.

    Is there a place anyone knows of to obtain the conectors the factory uses?

  4. bill green

    bill green Member

    Hi Adam call dave at whizzer tell him you need A six place male conector and six female pins. you will only use two of them the rest are standard spade conectors .hope this helps Bill Green whizzer 1-877-944-9937