CARROT-The DESTROYER
Member
Hey,
Somewhat new to the forum, but after much research, one of the main repetitive problems I had read about was vibration.
So for my first build, I made a sprung front engine mount to try to aleviate the vibration problem.
Being I have never ridden an MBC yet, - hopefully tomorrow!! - I have no previous experience to base my design upon.
Do you think this design should work? - Or can you suggest any improvements?
The spacer I used in the center does not go all the way to the top. It has about a 3/8" gap to actuate the spring. So it should also act as a stop gap as well.
I also used rubber at all engine mount points between the clamps to reduce any vibration.
Take a look at the pic's, tell me what you think.
Thanks,
Troy Fitz.
Somewhat new to the forum, but after much research, one of the main repetitive problems I had read about was vibration.
So for my first build, I made a sprung front engine mount to try to aleviate the vibration problem.
Being I have never ridden an MBC yet, - hopefully tomorrow!! - I have no previous experience to base my design upon.
Do you think this design should work? - Or can you suggest any improvements?
The spacer I used in the center does not go all the way to the top. It has about a 3/8" gap to actuate the spring. So it should also act as a stop gap as well.
I also used rubber at all engine mount points between the clamps to reduce any vibration.
Take a look at the pic's, tell me what you think.
Thanks,
Troy Fitz.