stripped the spline on the drive shaft

Discussion in '2-Stroke Engines' started by nathanl, May 9, 2010.

  1. nathanl

    nathanl New Member

    So I managed to strip the spline that holds the engine cog in place. I can tighten the nut on the outside till it turns over the engine and then it just works its way free in a minute or so. Can this shaft be easily replaced, or would I be better off just tacking that cog in place?

  2. Dilly Bar Rob

    Dilly Bar Rob Member

    Just tack it and be done with it.
  3. Hajuu

    Hajuu Member