Michael80chinadoll
Active Member
My throttle slide is stuck after i was moving the needle clip down,i dont have many tools that i can use to get it out of the carb,it was working fine before i touched the carb
Stuck throttle slide
- Thread starter Michael80chinadoll
- Start date
It probably happened because you didn't realise that you can only put it in one way.
Did you notice the black "barrel' slide has a groove all the way down it ???, (see in picture below), ...There is a protruding nub on the inside of the barrel chamber of the carburetor on the right hand side when it is mounted on the bike, It is the opposite side of where the idle screw is.
That nub has to ride inside that black barrel groove or it will get stuck inside and you will have to carefully pull it out with needle nose pliers or something similar if you really got it jammed in there.
Once you get it in their correctly it will slide up and down quite easily with no resistance...I am almost willing to bet that you strong armed the twist cap back on there making the jamming much worse.
Chainlube
Well-Known Member
You put the slide in backwards. There is a idle bevel in one side and a keyway in the other. Maybe you can get it to pop up with a flat screwdriver.
Gordy
Well-Known Member
Try pulling out the idle screw
Michael80chinadoll
Active Member
I tried to pull it out with needle nose pliers and a small piece broke off
Michael80chinadoll
Active Member
Yeah i just realised i did,thats what i get for rushing lol
Chainlube
Well-Known Member
Do you have the carb in your hand?
Michael80chinadoll
Active Member
No im inside rn so i can get internet
Michael80chinadoll
Active Member
Gordy
Well-Known Member
Grap the cap in one hand and the carb in the other and give it a good yank.
Similar threads
