T/F All crank cases are the same

[INTP_ty]

?

 

[crassius]

F

 

[gary55]

ZZZZZZZZZZZZZZZ

 

[INTP_ty]

My HT had a hairline fracture

 

[Frankenstein]

Are we speaking branding or exacting standards from one piece to the next out of a factory, because neither are true.

 

[CrazyDan]

You could always buy the zeda cnc bottom end, stroker crank and put all japanese bearings in.

 

[Psychochick]

The primary difference is crank and con rod size that's why you have to check side of rod,and where your piston pin is located on piston low pin is short rod high pin is long rod.
I'm pretty sure but if I'm wrong I am sure one of you nice guys will call me out on it.

 

[Frankenstein]

The primary difference is crank and con rod size that's why you have to check side of rod,and where your piston pin is located on piston low pin is short rod high pin is long rod.
I'm pretty sure but if I'm wrong I am sure one of you nice guys will call me out on it.

I'm not nice and I'd still call you out on it, but in this case you would be right.