Mark 1971
Member
- Local time
- 7:51 AM
- Joined
- May 30, 2021
- Messages
- 38
Today I looked into my intake and saw that the piston skirt hung about 1/8" to 1/16" of the piston skirt impending my intake when piston is TDCThe ports look really good for a cast AL head( one piece jug and head). Is it worth it to skirt the piston? And if so, do I go ahead a bevel both the cylinder ports ? Polish the exaust side too..? Im a new builder. Just built 1st bike 2 weeks ago.I am looking for torque. Top speed is not my main goal. I do 36mph all stock so far