Torque Wrench

[darwin]

This is 1 I bought years ago for a job I had, only used it for about 5 months and will probably never use it again. HF Pittsburg 1/2in up to 150 ft lbs. Company had a tester for accuracy and at 120lb test it was only off 1 ft lbs. Good enough for company standards to use. Cheap as hell price new.

 

[Wrench]

This is 1 I bought years ago for a job I had, only used it for about 5 months and will probably never use it again. HF Pittsburg 1/2in up to 150 ft lbs. Company had a tester for accuracy and at 120lb test it was only off 1 ft lbs. Good enough for company standards to use. Cheap as hell price new.

Sure those are great I own one exactly like it I use it all the time when tightening stuff 20 lbs and over

Ft lb 1/2" drive torque wrench is too big for a Motorbicycle engines
Their not very accurate at under 20 lbs. Their weight & length makes ya over torque by accident
Besides it can't tighten any screws and bolts that require 7 ft lbs
BTW the screws and bolt's that take 7 ft lbs and under are some of the most common to strip out when tightening by hand