Z
Zomby Builder
Guest
Nirve build
I have made a smaller sprocket to fit the 5 to 1 tranny. It is made by turning down a stock one to 5/8 inch & tig welding it inside a standard 8 tooth by 5/8.
I want to build a Nirve with a NuVinci too. I would like to mount the motor centered in the frame. Only thing is The Honda 50 with adapter & 5 to 1 measures 12 3/4 inches. To do this & use the freewheel crank that (you) Scooterguy have had so much success with. Crank arm clearance needs to be W-I-D-E. I suspect you have thought of this too. Any reasonable solutions to this issue???
I have made a smaller sprocket to fit the 5 to 1 tranny. It is made by turning down a stock one to 5/8 inch & tig welding it inside a standard 8 tooth by 5/8.
I want to build a Nirve with a NuVinci too. I would like to mount the motor centered in the frame. Only thing is The Honda 50 with adapter & 5 to 1 measures 12 3/4 inches. To do this & use the freewheel crank that (you) Scooterguy have had so much success with. Crank arm clearance needs to be W-I-D-E. I suspect you have thought of this too. Any reasonable solutions to this issue???
Last edited by a moderator: