tune pipe

redneckracing674

Well-Known Member
Local time
6:19 AM
Joined
Dec 18, 2021
Messages
353
Location
Lancaster Motor Speedway SC
so i have this suzuki 125, with a giant exhaust port. its over 1.5 inches in diameter. if i got a pipe, for a cr125, would it be better for me to weld the smallest end on a plate, so it necks down, or cut it off where the pipe is about the right dia, and weld on a flange
 
so i have this suzuki 125, with a giant exhaust port. its over 1.5 inches in diameter. if i got a pipe, for a cr125, would it be better for me to weld the smallest end on a plate, so it necks down, or cut it off where the pipe is about the right dia, and weld on a flange
What are you putting it on?
 
Cr 80... Kx 85 ... KTM sx65... The 50cc scooter pipes are going to be the best performance... A 125 is going to be huge... but I'm a noob with only 45 years building 2 strokes since I was a kid...
 
Back
Top