I
Irish John
Guest
Anybody know the correct valve gaps for the Huangsheng motor? I was told they'd probably be same as for Honda GXH which I was told were .07 both valves which is not what I've heard here. Any help would be appreciated. Also I don't find I need sealant to put the rocker cover back on. The original gasket works fine cos there's no pressure there.
Whatever the valve gaps are I fdound that adjusting them many ways I got to eliminate any valve noise but that wasn't what the engine wanted so I set them at the gaps they seemed most responsive at and that was 0.09 - 0.10 exhaust valve and 0.08 inlet valve. They rattle a bit at low revs but this is what makes my Huangsheng sing.
MBC EDIT: THIS THREAD HAS BEEN MOVED
Whatever the valve gaps are I fdound that adjusting them many ways I got to eliminate any valve noise but that wasn't what the engine wanted so I set them at the gaps they seemed most responsive at and that was 0.09 - 0.10 exhaust valve and 0.08 inlet valve. They rattle a bit at low revs but this is what makes my Huangsheng sing.
MBC EDIT: THIS THREAD HAS BEEN MOVED
Last edited by a moderator: