What kind of I belt do I need to get for my 100cc 4-stroke 156 F 3.5 horsepower bicycle engine I cannot find one anywhere and could somebody please tell me where to get one or the numbers off one I need to get or whatever it is I need to order I just can't even figure out what the type in here to find it even thank you
What kind of I belt do I need to get for My 100cc 4-stroke 156 F 3.5 horsepower bicycle engine
- Thread starter Rickp7241
- Start date
robe
Well-Known Member
Are you looking for a primary or secondary? The only primary ones I could find are too light weight.
Here is a secondary on AliExpress. I haven't tried it. I'm just going with the 415H chain that comes with the kit. Winter project.
Here is a secondary on AliExpress. I haven't tried it. I'm just going with the 415H chain that comes with the kit. Winter project.
michael whiteman
Well-Known Member
- Local time
- 8:35 AM
- Joined
- Mar 2, 2021
- Messages
- 944
I assume you are refering to the drive belt between the clutch and the jackshaft Rick. It should have a part number on it. My clutch has 20T and the big pulley has 100T. If yours is the same the belt probably is also. The belt that came on my 142F kit had this synchronous timing belt number HTD 575-5M-15.
HDT=Gates trademark ..... 575=length ..... 5M=Pitch ..... 15= Width ..... it has fiberglass reinforcing
Gates and D&D Power Drive have all the sizes imaginable. Also many are listed on Amazon
HDT=Gates trademark ..... 575=length ..... 5M=Pitch ..... 15= Width ..... it has fiberglass reinforcing
Gates and D&D Power Drive have all the sizes imaginable. Also many are listed on Amazon
darwin
Well-Known Member
- Local time
- 9:35 AM
- Joined
- May 26, 2008
- Messages
- 9,209
Will Grubee belts work? They have a couple of choices.
www.grubee.net
SkyHawk 4 Cycle________ ENGINES, KITS AND PARTS
GruBee Skyhawk CVT and T Belt drive 4G transmission kits including service parts for motorizing standard bikes and also Multi Speed Shift for Gru-Bee Gt2A frames with built in Gas tanks.
www.grubee.net
