Which malossi wrist pin and bearing?

[Wags]

My question is at treatland which malossi wrist pin and bearing is correct for the 66cc 38 stroke pk80?

 

[Street Ryderz]

From what I see they dont have the wrist pin but I didnt look hard! The bearing from Malossi is the first one listed 10x14x13 mm and there are even better ones than that like the Stage 6 10x14x15 mm the extra length helps to take up the slop(end play) also the Stage 6 ones IMO have a better design they are used by scooter tuners making high out put small displacement screamers!So if they can withstand that our little engine will only benifit from there use!In the last pic you can see both big and small end bearing types I prefer the upper set!

 

[Wags]

Isnt the stock wrist pin 10×37or 10x 38 or something like that?I was told they have something that will work.

 

[Street Ryderz]

Isnt the stock wrist pin 10×37or 10x 38 or something like that?I was told they have something that will work.

Sounds about right!Idk they may have had it at one time but I put 10mm wrist pin in their search under engine parts and nothing!Unfortunatly I mostly see the wrist pin with the piston when it comes to malossi,athena,airsal,polini,and all the good quality one that are of a simular size to ours!But then some of those makes cost $60-$80 so yeah it should come with the pin,clips,bearing,rings and a gasket set lol.

 

[DuctTapedGoat]

10x14x13
Search that to these forums and you can find the pin length somewhere

This is from the titanium wrist pin description online
Stock wrist pins weigh 14.6 grams.
Length 1.530 inches x .3935 diameter.

Math says
1.53 inches is 38.86 millimeters.
0.3935 inches is 9.99 millimeters.


These guys have malossi
http://www.sip-scootershop.com/en/main/base/results.aspx?t=Bearing Gudgeon Pin