Anytime Im asked to gouge I make sure to f*** up enough to never be asked again, I hate the noise and I could never stand to practice enough to get any good during my apprenticeship.
It's a new to me trailer now. A little more steel for the corners and I'm good. I have to weld the tongue jack on and run some wires for the lights. Then look for some decking.
Fluxcore wire is 100% pull. I would bevel your ends for a buttweld bevel at a 30degree angle but leave a 16th to an 8th untouched for a structural root weld
(1rst pass) between passes grind out just a hair off the entire weld. This is most important to eliminate a contaminated weld clean with wire wheel then start next pass. The cap weld should over top your metal of a 16th of an inch (cap) If done correctly a butt weld is as strong as the come
Welding train cars 10years ago age 30
It's a new to me trailer now. A little more steel for the corners and I'm good. I have to weld the tongue jack on and run some wires for the lights. Then look for some decking.