wont start after running fine

Discussion in '2-Stroke Engines' started by notsoqik, Aug 11, 2008.

  1. notsoqik

    notsoqik New Member

    Checked fire, very weak. Found thread on taking ohms readings on mag and cdi. Mag tests fine but cdi failed 2 out of 3 readings. (Open). Can any one tell me if these cdi's burn out regularilly? This motor has like only 10 hours on it.

  2. pedalpower

    pedalpower Member

    if you have weak fire I would suspect the plug wire or plug/gap. did you replace wire connections with soldered blades? did you wire up the kill switch-disconnect it and try.

    cause/effect is ify at best. pretty soon after start up I was riding along and my mag fried. replaced cdi and mag. I've ordered a batch of 3 cdi and a couple extra mag coils.